Cupra

Complete production documentation for the manufacture of an injection mould. This documentation consisted of a 3D assembly of the mould and 2D production drawings, including the assembly. This part was intended for the automotive industry, specifically for CUPRA cars.

Design requirements:

1. Form 1+1
2. Product material: APIGO E_350
3. Patterned parts
4. Deforming mouldings using jaws, both on the AS side and on the DS side
5. The jaws are controlled by hydraulic cylinders.
6. The jaws depart from the AS side at two angles.
7. On the DS side, the jaws are controlled by locking hydraulic cylinders.
8. Ejecting the product using pin ejectors
9. Single hot nozzle, cold channel, banana inlets
10. Ball bearing guide for ejector plates
11. Radius on nozzle R 15.5 mm
12. Mould dimensions 596x946x538